Archives

Malahini Boat Build By Elio Ascenzo- Stage 6

On August 27, 2019, in Builder Blogs, Glen-L Styles, Outboard Powered, Plywood Construction, by Elio Ascenzo
0

In this stage of building the Glen-L Malahini, I focused on the hardware, trailer set up, sign writing and registration for the boat. I also decided to add carpet to the floor. Related Images:

Malahini Boat Build By Elio Ascenzo- Stage 5

On August 22, 2019, in Builder Blogs, Outboard Powered, Plywood Construction, by Elio Ascenzo
1

During this stage of building the Glen-L Malahini, I sanded the timber back, applied 4 coats of epoxy and then applied paint and clear finish. I decided to go for a blue stripe in the middle of the boat, blue and white on the sides and a natural timber finish elsewhere. Related Images:

Malahini Boat Build By Elio Ascenzo- Stage 4

On August 20, 2019, in Outboard Powered, Plywood Construction, by Elio Ascenzo
0

In the fourth stage of building the Glen-L Malahini, the boat was flipped and all the framework for the internal parts of the boat were made. The seats were made out of Kauri and Mahogany veneer. I made the decking out of 12mm solid Sapelli Mahogany, with a slight V-groove at the joins. Related Images:

Malahini Boat Build By Elio Ascenzo- Stage 2

On August 13, 2019, in Builder Blogs, Outboard Powered, Plywood Construction, by Elio Ascenzo
0

For the second stage of the Glen-L Malahini build, I chose to use a Sapelli Mahogany marine ply veneer. As the sheets weren’t long enough, I had to put two joins in the boat, as seen in the images. Related Images:

Malahini Boat Build By Elio Ascenzo – Stage 1

On August 9, 2019, in Builder Blogs, Outboard Powered, Plywood Construction, by Elio Ascenzo
0

I am Elio Ascenzo from Melbourne, Australia and when I decided to build the Glen-L Malahini, it was a bit more difficult starting off here in Melbourne as I didn’t have the same timber choices as the boat builders in the USA. So, after a lot of research and discussions with timber merchants, I decided […]

%d bloggers like this: